MetalworkingFun Forum › Machining › General Metalworking Discussion v
I need some help with this repair

Thread Modes
I need some help with this repair
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#3
10-09-2017, 12:07 PM
Is there a plating company nearby?  If so have them plate the outside of the piston.  Before you go with that option put it in an oven at 180C to bake out the oil.
Reply
Thanks given by:


Messages In This Thread
I need some help with this repair - by Pete O - 10-09-2017, 05:28 AM
RE: I need some help with this repair - by TomG - 10-09-2017, 09:07 AM
RE: I need some help with this repair - by Dr Stan - 10-09-2017, 12:07 PM
RE: I need some help with this repair - by f350ca - 10-09-2017, 12:19 PM
RE: I need some help with this repair - by SteveG - 10-09-2017, 08:30 PM
RE: I need some help with this repair - by Pete O - 10-09-2017, 09:41 PM
RE: I need some help with this repair - by TomG - 10-10-2017, 07:01 AM
RE: I need some help with this repair - by f350ca - 10-10-2017, 08:29 AM
RE: I need some help with this repair - by Pete O - 10-10-2017, 04:45 PM
RE: I need some help with this repair - by Pete O - 10-11-2017, 04:38 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 05:25 AM
RE: I need some help with this repair - by TomG - 10-14-2017, 07:38 AM
RE: I need some help with this repair - by f350ca - 10-14-2017, 09:08 AM
RE: I need some help with this repair - by Pete O - 10-14-2017, 04:59 PM
RE: I need some help with this repair - by Pete O - 10-16-2017, 04:01 AM



Users browsing this thread: 2 Guest(s)