MetalworkingFun Forum › Machining › General Metalworking Discussion v
Morse Taper Sleeves

Thread Modes
Morse Taper Sleeves
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#3
07-13-2017, 10:43 PM
(07-13-2017, 10:11 PM)Pumpjack Wrote: I would think i would want hardened ones ,if you like me and all ways dinging and dropping them. would be very easy to get a high spot ,and you know what that means. thats when i get a slip and then i tear up the inside taper.

Smiley-signs009
Reply
Thanks given by:


Messages In This Thread
Morse Taper Sleeves - by f350ca - 07-01-2017, 05:46 PM
RE: Morse Taper Sleeves - by Pumpjack - 07-13-2017, 10:11 PM
RE: Morse Taper Sleeves - by Dr Stan - 07-13-2017, 10:43 PM
RE: Morse Taper Sleeves - by f350ca - 07-14-2017, 07:03 AM



Users browsing this thread: 1 Guest(s)