06-06-2017, 03:33 PM
I've had a chat with Tony from Lathes.co.uk today and he thinks it could be a 3 1/2 morse taper or some other eaven a possible a one off, He's now included this lathe on his site and I'm providing all information I have.
I've sent 2 emails to Turnell & Odell some weeks back to two different departments without reply, perhaps a simple phone call will be the way to go.
I had looked on Wikipedia and read that there was only one 1/2 morse taper and that was the 4 1/2 but then again I don't think all info on that site is 100% accurate.
So, still lost with this taper but hope someone will have some Idea in the future. Thanks Andrew & Mayhem for your comments :)
I've sent 2 emails to Turnell & Odell some weeks back to two different departments without reply, perhaps a simple phone call will be the way to go.
I had looked on Wikipedia and read that there was only one 1/2 morse taper and that was the 4 1/2 but then again I don't think all info on that site is 100% accurate.
So, still lost with this taper but hope someone will have some Idea in the future. Thanks Andrew & Mayhem for your comments :)