The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machinery › Lathes v
[HELP] What's mt taper?

Thread Modes
Help What's mt taper?
Andy T Offline
Freshman
**
Posts: 30
Threads: 4
Joined: May 2017
Location: England
#1
06-06-2017, 03:27 AM
Hi all, the headstock spindle of my lathe has a taper in it. MT3 is to small & MT4 is to big. Any idears what it could be ?
Drawing not to scale and measurements + - 0.005 ish
   
Reply
Thanks given by:


Messages In This Thread
What's mt taper? - by Andy T - 06-06-2017, 03:27 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 03:34 AM
RE: What's mt taper? - by Andy T - 06-06-2017, 03:54 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 04:20 AM
RE: What's mt taper? - by awemawson - 06-06-2017, 04:25 AM
RE: What's mt taper? - by Mayhem - 06-06-2017, 06:38 AM
RE: What's mt taper? - by Andy T - 06-06-2017, 03:33 PM
RE: What's mt taper? - by awemawson - 06-06-2017, 03:44 PM
RE: What's mt taper? - by texx - 06-06-2017, 04:07 PM
RE: What's mt taper? - by Roadracer_Al - 06-06-2017, 04:29 PM
RE: What's mt taper? - by texx - 06-06-2017, 05:34 PM
RE: What's mt taper? - by f350ca - 06-06-2017, 06:06 PM
RE: What's mt taper? - by Andy T - 06-07-2017, 04:06 AM
RE: What's mt taper? - by Mayhem - 06-07-2017, 07:23 AM
RE: What's mt taper? - by Andy T - 06-07-2017, 08:39 AM
RE: What's mt taper? - by f350ca - 06-07-2017, 08:01 AM
RE: What's mt taper? - by Mayhem - 06-07-2017, 08:43 AM



Users browsing this thread: 2 Guest(s)