MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tooling-Slitter advice

Thread Modes
Tooling-Slitter advice
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
EdK (03-03-2017)
#12
03-03-2017, 05:22 AM
I made my own, without a key, for the very reason that Tom mentions.


.jpg   1671a.JPG (Size: 77.54 KB / Downloads: 34)

.jpg   1671b.JPG (Size: 76.13 KB / Downloads: 34)
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Tooling-Slitter advice - by pepi - 02-28-2017, 07:51 AM
RE: Tooling-Slitter advice - by rleete - 02-28-2017, 09:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-01-2017, 12:34 AM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 06:22 PM
RE: Tooling-Slitter advice - by TomG - 03-01-2017, 07:47 PM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 09:25 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 10:10 AM
RE: Tooling-Slitter advice - by pepi - 03-02-2017, 10:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-02-2017, 02:10 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 06:07 PM
RE: Tooling-Slitter advice - by wawoodman - 03-02-2017, 08:52 PM
RE: Tooling-Slitter advice - by Mayhem - 03-03-2017, 05:22 AM
RE: Tooling-Slitter advice - by pepi - 03-03-2017, 07:38 AM



Users browsing this thread: 1 Guest(s)