MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tooling-Slitter advice

Thread Modes
Tooling-Slitter advice
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#5
03-01-2017, 07:47 PM
Greg,

Why do you need a slitting saw to cut a keyway? I normally end mill mine.  17428

Unless you are cutting an internal keyway, then you'll need a broach.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Tooling-Slitter advice - by pepi - 02-28-2017, 07:51 AM
RE: Tooling-Slitter advice - by rleete - 02-28-2017, 09:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-01-2017, 12:34 AM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 06:22 PM
RE: Tooling-Slitter advice - by TomG - 03-01-2017, 07:47 PM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 09:25 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 10:10 AM
RE: Tooling-Slitter advice - by pepi - 03-02-2017, 10:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-02-2017, 02:10 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 06:07 PM
RE: Tooling-Slitter advice - by wawoodman - 03-02-2017, 08:52 PM
RE: Tooling-Slitter advice - by Mayhem - 03-03-2017, 05:22 AM
RE: Tooling-Slitter advice - by pepi - 03-03-2017, 07:38 AM



Users browsing this thread: 1 Guest(s)