03-01-2017, 06:22 PM
The key slot will be along the length of the bushing, bushing will not be a sold circle looking from the end.
Greg
Greg
Magazines have issues, everything else has problems
|
Tooling-Slitter advice
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tooling-Slitter advice - by pepi - 02-28-2017, 07:51 AM
RE: Tooling-Slitter advice - by rleete - 02-28-2017, 09:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-01-2017, 12:34 AM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 06:22 PM
RE: Tooling-Slitter advice - by TomG - 03-01-2017, 07:47 PM
RE: Tooling-Slitter advice - by pepi - 03-01-2017, 09:25 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 10:10 AM
RE: Tooling-Slitter advice - by pepi - 03-02-2017, 10:32 AM
RE: Tooling-Slitter advice - by Roadracer_Al - 03-02-2017, 02:10 PM
RE: Tooling-Slitter advice - by TomG - 03-02-2017, 06:07 PM
RE: Tooling-Slitter advice - by wawoodman - 03-02-2017, 08:52 PM
RE: Tooling-Slitter advice - by Mayhem - 03-03-2017, 05:22 AM
RE: Tooling-Slitter advice - by pepi - 03-03-2017, 07:38 AM
|
Users browsing this thread: 1 Guest(s)