MetalworkingFun Forum › Machining › How-To's v
bit of advice needed

Thread Modes
bit of advice needed
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#6
01-02-2017, 05:28 PM
I'm using the non-contact type for now and it works just fine.

http://www.banggood.com/Wholesale-DT2234...mds=search

Ed
Reply
Thanks given by:


Messages In This Thread
bit of advice needed - by oldskoolron - 12-06-2016, 01:39 AM
RE: bit of advice needed - by pepi - 12-06-2016, 07:43 AM
RE: bit of advice needed - by Dr Stan - 12-06-2016, 11:11 AM
RE: bit of advice needed - by NormanV - 01-02-2017, 03:18 PM
RE: bit of advice needed - by wawoodman - 01-02-2017, 05:07 PM
RE: bit of advice needed - by EdK - 01-02-2017, 05:28 PM
RE: bit of advice needed - by Dr Stan - 01-06-2017, 12:01 AM



Users browsing this thread: 3 Guest(s)