MetalworkingFun Forum › Machining › Welding & Casting v
plasma tip

Thread Modes
plasma tip
Hawkeye Offline
Junior
****
Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada
#5
12-29-2016, 11:38 PM
I ordered a set of consumables for my CT-416 from China. The other day, I was checking the air flow and I noticed that the air was coming out at a sharp angle. Some of the tips had some burr around the centre hole. I can probably clean that up, but it's worth looking at every piece before using.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
plasma tip - by oldskoolron - 12-29-2016, 06:32 PM
RE: plasma tip - by f350ca - 12-29-2016, 09:47 PM
RE: plasma tip - by Dr Who - 12-29-2016, 10:22 PM
RE: plasma tip - by arvidj - 12-29-2016, 10:23 PM
RE: plasma tip - by Hawkeye - 12-29-2016, 11:38 PM
RE: plasma tip - by arvidj - 12-30-2016, 09:19 AM



Users browsing this thread: 1 Guest(s)