MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machining Chamfers

Thread Modes
Machining Chamfers
RobWilson
Unregistered
 
The following 2 users Like RobWilson's post:
EdK (10-09-2016), Mayhem (10-09-2016)
#8
10-09-2016, 10:27 AM
(10-08-2016, 05:58 PM)the penguin Wrote:
(10-08-2016, 05:11 PM)Mayhem Wrote: I see that BobCad is one step up on AmishCad, giving the ability to add colour to the print.

similar to AmishCad version 1.1.1.02 .....................

Surly If it was AmishCad   it would be version 1', 1".5/8  Rotfl


Rob
Reply
Thanks given by:


Messages In This Thread
Machining Chamfers - by EdK - 10-08-2016, 01:44 PM
RE: Machining Chamfers - by RobWilson - 10-08-2016, 01:53 PM
RE: Machining Chamfers - by EdK - 10-08-2016, 03:07 PM
RE: Machining Chamfers - by Mayhem - 10-08-2016, 05:11 PM
RE: Machining Chamfers - by the penguin - 10-08-2016, 05:58 PM
RE: Machining Chamfers - by wawoodman - 10-08-2016, 11:01 PM
RE: Machining Chamfers - by RobWilson - 10-09-2016, 10:24 AM
RE: Machining Chamfers - by RobWilson - 10-09-2016, 10:27 AM



Users browsing this thread: 3 Guest(s)