Opinions needed..pls

Hello There, Guest! Register

Thread Modes

Opinions needed..pls

EdK

Offline

Whipping Boy

Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

#13

10-01-2016, 11:39 AM

(10-01-2016, 10:15 AM)the penguin Wrote: your not relying on the lead screw for carriage motion, unless your threading.

Yup, using the lead screw for feeding is one of the weaknesses of most of the smaller lathes.

Ed

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Opinions needed..pls - by pepi - 09-30-2016, 07:11 AM

RE: Opinions needed..pls - by dallen - 09-30-2016, 09:18 AM

RE: Opinions needed..pls - by Dr Stan - 09-30-2016, 12:15 PM

RE: Opinions needed..pls - by EdK - 09-30-2016, 01:52 PM

RE: Opinions needed..pls - by Highpower - 09-30-2016, 02:29 PM

RE: Opinions needed..pls - by Vinny - 09-30-2016, 05:27 PM

RE: Opinions needed..pls - by the penguin - 09-30-2016, 07:43 PM

RE: Opinions needed..pls - by Sunset Machine - 10-01-2016, 09:01 AM

RE: Opinions needed..pls - by Highpower - 10-01-2016, 10:20 AM

RE: Opinions needed..pls - by Dr Stan - 10-01-2016, 02:51 PM

RE: Opinions needed..pls - by EdK - 10-01-2016, 09:08 AM

RE: Opinions needed..pls - by the penguin - 10-01-2016, 10:15 AM

RE: Opinions needed..pls - by EdK - 10-01-2016, 11:39 AM

RE: Opinions needed..pls - by the penguin - 10-01-2016, 10:30 AM

RE: Opinions needed..pls - by PixMan - 10-03-2016, 09:03 PM

RE: Opinions needed..pls - by Vinny - 10-03-2016, 10:05 PM

RE: Opinions needed..pls - by Dr Stan - 10-04-2016, 01:30 AM

RE: Opinions needed..pls - by Dr Stan - 10-04-2016, 11:23 AM

RE: Opinions needed..pls - by pepi - 10-03-2016, 10:01 PM

RE: Opinions needed..pls - by Mayhem - 10-04-2016, 06:41 AM

RE: Opinions needed..pls - by Highpower - 10-04-2016, 11:28 PM

RE: Opinions needed..pls - by PixMan - 10-04-2016, 08:05 PM

Users browsing this thread: 5 Guest(s)