09-26-2016, 09:28 PM
I measured it ed and its 20mm thick ill ask oldmate when I see him next what they for I think he said cast iron an he said I be ok using them on mild steel and alloys seein im a beginner basically
|
just a few bits
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
just a few bits - by oldskoolron - 09-21-2016, 06:25 AM
RE: just a few bits - by Dr Stan - 09-21-2016, 09:23 AM
RE: just a few bits - by PixMan - 09-21-2016, 11:27 AM
RE: just a few bits - by oldskoolron - 09-23-2016, 06:37 PM
RE: just a few bits - by PixMan - 09-23-2016, 08:28 PM
RE: just a few bits - by oldskoolron - 09-25-2016, 04:13 AM
RE: just a few bits - by EdK - 09-25-2016, 09:20 AM
RE: just a few bits - by oldskoolron - 09-26-2016, 09:28 PM
RE: just a few bits - by bollie7 - 10-20-2016, 04:19 PM
RE: just a few bits - by DaveH - 10-20-2016, 05:37 PM
|
Users browsing this thread: 1 Guest(s)