MetalworkingFun Forum › Machining › General Metalworking Discussion v
Bending Question

Thread Modes
Bending Question
Rainman1 Offline
Freshman
**
Posts: 9
Threads: 2
Joined: Feb 2015
Location: NY
#4
09-25-2016, 07:57 AM
So, in looking for the thickness answer I found that I can get it in 12 or 14 ga also if this helps. Would prefer the heaviest I can use but probably better done with "standard" sheet metal shop equipment.

Thanks again
Reply
Thanks given by:


Messages In This Thread
Bending Question - by Rainman1 - 09-25-2016, 07:05 AM
RE: Bending Question - by pepi - 09-25-2016, 07:28 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:51 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 07:57 AM
RE: Bending Question - by ieezitin - 09-25-2016, 08:13 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:32 AM
RE: Bending Question - by Rainman1 - 09-25-2016, 08:34 AM
RE: Bending Question - by dallen - 09-25-2016, 10:13 AM
RE: Bending Question - by ieezitin - 09-25-2016, 07:34 PM
RE: Bending Question - by aametalmaster - 09-25-2016, 08:38 PM
RE: Bending Question - by PixMan - 09-26-2016, 08:01 PM
RE: Bending Question - by Dr Stan - 09-26-2016, 10:58 PM



Users browsing this thread: 2 Guest(s)