|
just a few bits
|
09-23-2016, 06:37 PM
I only have the older style tool holder but do have a quik change one with 1 holder ..if I make it fit that id still have to take off 1/4 inch off the tool or if I use my normal one will need to cut it in half to fit .I think the best way would be as mentioned an set it up in the quik change so I always have it set up correctly an not have to stuff around shimming it ect
cheers |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
just a few bits - by oldskoolron - 09-21-2016, 06:25 AM
RE: just a few bits - by Dr Stan - 09-21-2016, 09:23 AM
RE: just a few bits - by PixMan - 09-21-2016, 11:27 AM
RE: just a few bits - by oldskoolron - 09-23-2016, 06:37 PM
RE: just a few bits - by PixMan - 09-23-2016, 08:28 PM
RE: just a few bits - by oldskoolron - 09-25-2016, 04:13 AM
RE: just a few bits - by EdK - 09-25-2016, 09:20 AM
RE: just a few bits - by oldskoolron - 09-26-2016, 09:28 PM
RE: just a few bits - by bollie7 - 10-20-2016, 04:19 PM
RE: just a few bits - by DaveH - 10-20-2016, 05:37 PM
|
