|
Anyone Ever Dealt With Tormach
|
09-10-2016, 02:24 PM
Thank you Ed, LMS had both tools (I did have to settle for 1/2" shanks), I was looking for, the cost from LMS with shipping was lower than Tormach's cost for just the bare tools. The surprising thing is LMS list them as Tormach made, so the same tool for a lower cost, DAMN!! I like that.
jack
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Anyone Ever Dealt With Tormach - by the penguin - 09-10-2016, 12:00 PM
RE: Anyone Ever Dealt With Tormach - by EdK - 09-10-2016, 12:26 PM
RE: Anyone Ever Dealt With Tormach - by the penguin - 09-10-2016, 02:24 PM
RE: Anyone Ever Dealt With Tormach - by Vinny - 09-10-2016, 05:49 PM
RE: Anyone Ever Dealt With Tormach - by EdK - 09-10-2016, 05:52 PM
RE: Anyone Ever Dealt With Tormach - by the penguin - 09-14-2016, 07:50 PM
RE: Anyone Ever Dealt With Tormach - by the penguin - 09-15-2016, 03:49 PM
RE: Anyone Ever Dealt With Tormach - by EdK - 09-15-2016, 04:06 PM
|
