04-12-2016, 08:56 AM
Hi Guys
Really hope somebody has had experience with these ( pictured ) or knows better.
We want to buy a Set of these from the Canadian Suppliers who know a lot less about which are the compatible CARBIDE INSERTS, besides the TNMA, SNMA and RNMA series which fit these HOGGERS.
We were thinking of using the TNMG (SNMG) 160404 331/332 Series, but were told by another good insert Supplier that they just might be too thick for these "LIL HOGGERS".
These look a lot better than the ones sold on Eeeek !!!
However, we just can't seem to be able to elicit a reasonably intelligent response from the Suppliers, who are not locals anyway.
Seeing these are sold Your side of the pond the METRIC ISO 160404 Series just might not fit the Imperials.
We wonder if the Guru here, MR PIXMAN, might have a better suggestion for a whole different Toolholder ???
If anybody does, He ought to know what's best
And we will appreciate some direction in this quandary.
These HOGGERS are advertised for good feed/Cut application and we hope our machine will be able to handle that seeing they are only an Inch in Diameter.
Looking forward to some serious enlightenment here as we are just about going crazy with both the Suppliers.
Thanks a stack in advance
aRM
Really hope somebody has had experience with these ( pictured ) or knows better.
We want to buy a Set of these from the Canadian Suppliers who know a lot less about which are the compatible CARBIDE INSERTS, besides the TNMA, SNMA and RNMA series which fit these HOGGERS.
We were thinking of using the TNMG (SNMG) 160404 331/332 Series, but were told by another good insert Supplier that they just might be too thick for these "LIL HOGGERS".
These look a lot better than the ones sold on Eeeek !!!
However, we just can't seem to be able to elicit a reasonably intelligent response from the Suppliers, who are not locals anyway.
Seeing these are sold Your side of the pond the METRIC ISO 160404 Series just might not fit the Imperials.
We wonder if the Guru here, MR PIXMAN, might have a better suggestion for a whole different Toolholder ???
If anybody does, He ought to know what's best
And we will appreciate some direction in this quandary.
These HOGGERS are advertised for good feed/Cut application and we hope our machine will be able to handle that seeing they are only an Inch in Diameter.
Looking forward to some serious enlightenment here as we are just about going crazy with both the Suppliers.
Thanks a stack in advance
aRM