MetalworkingFun Forum › Machining › Gunsmithing v
[PROJECT] New Guy

Thread Modes
Project New Guy
gunnersmate Offline
Freshman
**
Posts: 10
Threads: 1
Joined: Feb 2016
Location: Columbus, MI
#15
03-15-2016, 10:42 AM
No prints for the Hepburn, was  fortunate to have an opportunity to make profile templates of an original. I believe the American Single Shot Rifle Assoc. has Hepburn prints for sale at $10, if possible look at De Hasse's  Single Shot Rifles and Actions, contains a lot of info
Reply
Thanks given by:


Messages In This Thread
New Guy - by gunnersmate - 03-03-2016, 02:08 PM
RE: New Guy - by JScott - 03-03-2016, 02:25 PM
RE: New Guy - by gunnersmate - 03-03-2016, 04:43 PM
RE: New Guy - by Vinny - 03-03-2016, 05:37 PM
RE: New Guy - by Mayhem - 03-03-2016, 07:03 PM
RE: New Guy - by EdK - 03-03-2016, 07:07 PM
RE: New Guy - by TomG - 03-04-2016, 08:29 AM
RE: New Guy - by gunnersmate - 03-04-2016, 09:25 AM
RE: New Guy - by ScrapMetal - 03-10-2016, 05:50 PM
RE: New Guy - by gunnersmate - 03-13-2016, 03:05 PM
RE: New Guy - by gunnersmate - 03-13-2016, 03:10 PM
RE: New Guy - by gunnersmate - 03-13-2016, 03:21 PM
RE: New Guy - by gunnersmate - 03-13-2016, 03:27 PM
RE: New Guy - by JScott - 03-14-2016, 10:49 AM
RE: New Guy - by gunnersmate - 03-15-2016, 10:42 AM
RE: New Guy - by gunnersmate - 03-15-2016, 11:12 AM
RE: New Guy - by JScott - 03-15-2016, 02:24 PM
RE: New Guy - by gunnersmate - 03-17-2016, 03:51 PM
RE: New Guy - by MG-42 - 09-06-2016, 10:49 PM
RE: New Guy - by MG-42 - 09-06-2016, 10:50 PM



Users browsing this thread: 7 Guest(s)