02-26-2016, 12:28 PM
All dial bore gauges I've used are set with a ring gauge. This one appears to have the gauge built in, which is why they say to set it by pressing against a flat surface. What does the probe look like?
Tom
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)
MetalworkingFun Forum
›
Machining
›
Metrology
[HELP] Dial Hole Check Gage Need Help Travel /divisions
[HELP] Dial Hole Check Gage Need Help Travel /divisions
|
Help Dial Hole Check Gage Need Help Travel /divisions
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Dial Hole Check Gage Need Help Travel /divisions - by Kennyv - 02-26-2016, 10:45 AM
RE: Dial Hole Check Gage Need Help Travel /divisions - by TomG - 02-26-2016, 12:28 PM
RE: Dial Hole Check Gage Need Help Travel /divisions - by Kennyv - 02-26-2016, 03:32 PM
RE: Dial Hole Check Gage Need Help Travel /divisions - by DaveH - 02-26-2016, 03:50 PM
RE: Dial Hole Check Gage Need Help Travel /divisions - by EdK - 02-26-2016, 03:55 PM
RE: Dial Hole Check Gage Need Help Travel /divisions - by Vinny - 02-26-2016, 05:21 PM
RE: Dial Hole Check Gage Need Help Travel /divisions - by Kennyv - 02-26-2016, 07:04 PM
|
Users browsing this thread: 1 Guest(s)