12-28-2015, 12:58 AM
This isn't a great picture Willie but should give you some ideas.
![[Image: IMGP1255.jpg]](https://lh3.googleusercontent.com/-Mhoo1TTkoOY/S-XcXRo3VOI/AAAAAAAAAHw/c_9_-t4m084/s1440-Ic42/IMGP1255.jpg)
There are two mounts here, the one the slip roll is in comes straight out from the column, the one the vice is in allows you to go cross wise. They're 2 1/2 square tube with a 3/16 wall, 2 inch square on the vise and slip roll slip in the same as a receiver hitch on a truck. They're cross drilled for a locking pin as well. Have mounts for these, the bender I mentioned and a motorized chuck for welding.
There are two mounts here, the one the slip roll is in comes straight out from the column, the one the vice is in allows you to go cross wise. They're 2 1/2 square tube with a 3/16 wall, 2 inch square on the vise and slip roll slip in the same as a receiver hitch on a truck. They're cross drilled for a locking pin as well. Have mounts for these, the bender I mentioned and a motorized chuck for welding.
Free advice is worth exactly what you payed for it.
Greg
Greg