Is there no "how not to" heading?

[stevec]

Okay, I found the shaper in pic #3.
The reason pic #2 doesn't show the blocking and steel bar bolted to the lathe and the mill to steady them is because it isn't there yet.
:s
Here's a pic of the snowblower. Unfortunately the photo documentation is a bit sporadic. I was very busy!
   

Here's the ramp set-up for loading my Allis Chalmers tractors, thanks to my bud's flatbed trailer and some ingenuity on his part.

  2009-08-11_050610_SteveMBN1.jpg (Size: 48.17 KB / Downloads: 148)

Here's the first tractor going in. It's a project I've been doing for years now. It's configured in the "Model IB" or Industrial B model.

  2009-08-11_050917_SteveMBN3.jpg (Size: 50.1 KB / Downloads: 148)
Here goes the 2nd tractor, an AC Model CA

  2009-08-11_051411_SteveMBN5.jpg (Size: 36.38 KB / Downloads: 149)

Finally the third, an AC model B with loader (and forks) of my design and manufacture. On the 3pt.

  2009-08-11_051245_SteveMBN6.jpg (Size: 48.9 KB / Downloads: 150)

I'll take another break,