|
Latest addition - NOS gage blocks
|
|
11-19-2015, 07:03 PM
Definitely good enough for shop use, but I would do a sanity check on them just the same. After all, they were made in China. Clean them and check them with a good, well calibrated tenth reading micrometer. You should make sure they all measure up to what they say they are before trusting them.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) Thanks given by: JScott
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Latest addition - NOS gage blocks - by JScott - 11-19-2015, 09:49 AM
RE: Latest addition - NOS gage blocks - by CNCAZ - 11-19-2015, 02:03 PM
RE: Latest addition - NOS gage blocks - by Highpower - 11-19-2015, 06:01 PM
RE: Latest addition - NOS gage blocks - by TomG - 11-19-2015, 07:03 PM
RE: Latest addition - NOS gage blocks - by JScott - 11-20-2015, 08:00 AM
RE: Latest addition - NOS gage blocks - by wawoodman - 11-19-2015, 08:32 PM
RE: Latest addition - NOS gage blocks - by krv3000 - 11-21-2015, 04:38 PM
RE: Latest addition - NOS gage blocks - by Jurskas - 04-05-2016, 02:30 PM
RE: Latest addition - NOS gage blocks - by JScott - 04-06-2016, 12:49 PM
|
