MetalworkingFun Forum › Machining › General Metalworking Discussion v
"Vice Hold Downs"

Thread Modes
"Vice Hold Downs"
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#10
11-19-2015, 11:52 AM
it fits onto something because of the dovetail on the one side of it.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
"Vice Hold Downs" - by Highpower - 11-14-2015, 03:56 PM
RE: "Vice Hold Downs" - by EdK - 11-14-2015, 04:05 PM
RE: "Vice Hold Downs" - by Highpower - 11-14-2015, 06:18 PM
RE: "Vice Hold Downs" - by Dr Stan - 11-14-2015, 05:14 PM
RE: "Vice Hold Downs" - by Dr Stan - 11-14-2015, 10:29 PM
RE: "Vice Hold Downs" - by TomG - 11-15-2015, 11:23 AM
RE: "Vice Hold Downs" - by Pete O - 11-17-2015, 11:11 PM
RE: "Vice Hold Downs" - by PixMan - 11-19-2015, 04:35 AM
RE: "Vice Hold Downs" - by Sunset Machine - 11-19-2015, 10:54 AM
RE: "Vice Hold Downs" - by dallen - 11-19-2015, 11:52 AM
RE: "Vice Hold Downs" - by Vinny - 11-19-2015, 07:23 PM
RE: "Vice Hold Downs" - by Pete O - 11-23-2015, 05:40 PM



Users browsing this thread: 1 Guest(s)