10-18-2015, 08:16 PM
Being carbide tipped, you could easily (and safely) run those a LOT faster than those speeds.
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
Annular cutters vs. Silver and Deming?
Annular cutters vs. Silver and Deming?
|
Annular cutters vs. Silver and Deming?
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Annular cutters vs. Silver and Deming? - by wawoodman - 10-18-2015, 12:08 PM
RE: Annular cutters vs. Silver and Deming? - by PixMan - 10-18-2015, 05:42 PM
RE: Annular cutters vs. Silver and Deming? - by wawoodman - 10-18-2015, 06:03 PM
RE: Annular cutters vs. Silver and Deming? - by DaveH - 10-18-2015, 06:14 PM
RE: Annular cutters vs. Silver and Deming? - by PixMan - 10-18-2015, 08:16 PM
|
Users browsing this thread: 1 Guest(s)