The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Annular cutters vs. Silver and Deming?

Thread Modes
Annular cutters vs. Silver and Deming?
wawoodman Offline
Junior
****
Posts: 340
Threads: 24
Joined: Aug 2014
Location: Seattle, WA
#1
10-18-2015, 12:08 PM
I'v been looking at annular cutters (think hole saws on steroids) as an alternative to large drill bits, ~9/16 and up, in both the mill and the lathe. It seems a pretty good way to get to a large diameter, before going to the boring bar or reamer.

Has anyone tried it? Any comments?
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:


Messages In This Thread
Annular cutters vs. Silver and Deming? - by wawoodman - 10-18-2015, 12:08 PM



Users browsing this thread: 1 Guest(s)