09-19-2015, 06:19 AM
My Nikcole insert does not sit in line or parallel with the tool holder either, like you i was thinking it was a dud.
I have had a little trouble with chatter too but also success so my story is the same as yours.
I am waiting to purchase the threading bits to try them out, i am waiting on a silly cheap post on fle-bays to snatch them up like i did last time on some parting off inserts, I robbed they guy by paying $2.00 each for ten.
Anthony.
I have had a little trouble with chatter too but also success so my story is the same as yours.
I am waiting to purchase the threading bits to try them out, i am waiting on a silly cheap post on fle-bays to snatch them up like i did last time on some parting off inserts, I robbed they guy by paying $2.00 each for ten.
Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.