MetalworkingFun Forum › Machining › General Metalworking Discussion v
Need an HF Coupon

Thread Modes
Need an HF Coupon
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#3
08-11-2015, 11:49 AM
Not seen or found that coupon before. Will HF honor them? Have you used them?

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Need an HF Coupon - by chucketn - 08-11-2015, 11:04 AM
RE: Need an HF Coupon - by EdK - 08-11-2015, 11:39 AM
RE: Need an HF Coupon - by chucketn - 08-11-2015, 11:49 AM
RE: Need an HF Coupon - by EdK - 08-11-2015, 11:59 AM
RE: Need an HF Coupon - by EdK - 08-11-2015, 12:03 PM
RE: Need an HF Coupon - by chucketn - 08-11-2015, 12:19 PM
RE: Need an HF Coupon - by chucketn - 08-11-2015, 02:25 PM
RE: Need an HF Coupon - by Vinny - 08-11-2015, 05:16 PM
RE: Need an HF Coupon - by chucketn - 08-11-2015, 07:11 PM
RE: Need an HF Coupon - by Charles Spencer - 08-12-2015, 11:05 AM



Users browsing this thread: 9 Guest(s)