MetalworkingFun Forum › Machining › General Metalworking Discussion v
pins

Thread Modes
pins
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#8
07-29-2015, 06:08 PM
(07-29-2015, 08:48 AM)TomG Wrote: Depends on the size of the shaft and the power through the gears Ed. The shear force on a small diameter shaft might easily reach 1800 pounds. There isn't enough info available to know if that would work or not.

Tom

I figured I'd get called on that. It was just a SWAG on my part. It wasn't the first time nor will it be the last time I was wrong. Blush

Ed
Reply
Thanks given by:


Messages In This Thread
pins - by Vinny - 07-28-2015, 08:40 PM
RE: pins - by TomG - 07-28-2015, 09:03 PM
RE: pins - by Vinny - 07-28-2015, 09:09 PM
RE: pins - by f350ca - 07-28-2015, 10:37 PM
RE: pins - by EdK - 07-29-2015, 05:18 AM
RE: pins - by TomG - 07-29-2015, 08:48 AM
RE: pins - by EdK - 07-29-2015, 06:08 PM
RE: pins - by Sunset Machine - 07-29-2015, 10:33 AM
RE: pins - by TomG - 07-29-2015, 06:43 PM
RE: pins - by Vinny - 07-29-2015, 07:48 PM



Users browsing this thread: 2 Guest(s)