I need to bond two gears together. The smaller one has a hub that will press fit into the larger one and will be pinned. I'd also like to locktite it just to make sure it's not going anywhere (these will be in a gearbox). Which locktite should I use? The only stuff I have here right now is the red thread locker so I'll need to hit Fastenal to pick it up.
07-23-2015, 07:17 PM (This post was last modified: 07-23-2015, 07:21 PM by dallen.)
green bearing locker don't know the number, stuffs expensive so I would hit up one of your local bearing houses and see if they have it in the little squeeze tubes
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
(07-24-2015, 09:55 AM)Sunset Machine Wrote: You could use the stuff for press fits.... I like the 680.
Yes that is another good one.
If the fit is less than ideal the 680 is great because it is what they consider a "medium viscosity" so it will take up some clearance if any. Not much but I believe it is something like .005" in their literature.
Earlier I ordered a 50ml bottle on ebay for about $18. Fastenal had some other brand for $25 (but it appears you have to buy 6 bottles!) Anyway it should be here Thursday. I still have to turn two sleeves and a bunch of other non-metalworking stuff this weekend so Thurs is fine.