MetalworkingFun Forum › Machining › General Metalworking Discussion v
pins

Thread Modes
pins
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
f350ca (07-29-2015)
#5
07-29-2015, 05:18 AM
A 1/8" roll pin has a breaking strength of 1800lbs. According to McMaster "Breaking strength is measured as double shear, which is the force required to break a pin into three pieces.".
I would think that should be more than adequate.

Ed
Reply
Thanks given by:


Messages In This Thread
pins - by Vinny - 07-28-2015, 08:40 PM
RE: pins - by TomG - 07-28-2015, 09:03 PM
RE: pins - by Vinny - 07-28-2015, 09:09 PM
RE: pins - by f350ca - 07-28-2015, 10:37 PM
RE: pins - by EdK - 07-29-2015, 05:18 AM
RE: pins - by TomG - 07-29-2015, 08:48 AM
RE: pins - by EdK - 07-29-2015, 06:08 PM
RE: pins - by Sunset Machine - 07-29-2015, 10:33 AM
RE: pins - by TomG - 07-29-2015, 06:43 PM
RE: pins - by Vinny - 07-29-2015, 07:48 PM



Users browsing this thread: 2 Guest(s)