MetalworkingFun Forum › Machining › General Metalworking Discussion v
pins

Thread Modes
pins
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#4
07-28-2015, 10:37 PM
Would a roll pin work? Think they are semi hard. Drill a 1/8th hole and a 1/8 roll pin taps in snug. Next thought is a tapered pin, but then you have to buy the reamer and the pin but they work quite well.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
pins - by Vinny - 07-28-2015, 08:40 PM
RE: pins - by TomG - 07-28-2015, 09:03 PM
RE: pins - by Vinny - 07-28-2015, 09:09 PM
RE: pins - by f350ca - 07-28-2015, 10:37 PM
RE: pins - by EdK - 07-29-2015, 05:18 AM
RE: pins - by TomG - 07-29-2015, 08:48 AM
RE: pins - by EdK - 07-29-2015, 06:08 PM
RE: pins - by Sunset Machine - 07-29-2015, 10:33 AM
RE: pins - by TomG - 07-29-2015, 06:43 PM
RE: pins - by Vinny - 07-29-2015, 07:48 PM



Users browsing this thread: 2 Guest(s)