|
Face Mill
|
07-12-2015, 01:24 AM
The drawbar is what keeps the tools from falling out and spinning. As you tighten the drawbar, it pulls the tool/collet up inside the spindle, what the taper compresses the collet to hold the tool.
Does your drill chuck have a straight shank that goes into the collet or does it have an R8 one?
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Face Mill - by DaveH - 07-11-2015, 07:42 PM
RE: Face Mill - by EdK - 07-11-2015, 08:22 PM
RE: Face Mill - by Thumb - 07-11-2015, 08:49 PM
RE: Face Mill - by DaveH - 07-11-2015, 09:12 PM
RE: Face Mill - by Thumb - 07-11-2015, 11:24 PM
RE: Face Mill - by DaveH - 07-11-2015, 09:08 PM
RE: Face Mill - by EdK - 07-11-2015, 10:04 PM
RE: Face Mill - by Thumb - 07-11-2015, 11:45 PM
RE: Face Mill - by arvidj - 07-12-2015, 08:18 AM
RE: Face Mill - by Mayhem - 07-12-2015, 01:24 AM
RE: Face Mill - by Thumb - 07-12-2015, 01:48 AM
RE: Face Mill - by schor - 07-12-2015, 02:45 AM
RE: Face Mill - by Mayhem - 07-12-2015, 05:27 AM
RE: Face Mill - by Thumb - 07-12-2015, 01:13 PM
RE: Face Mill - by PixMan - 07-12-2015, 03:18 PM
RE: Face Mill - by Charles Spencer - 07-13-2015, 07:16 AM
|
