MetalworkingFun Forum › Machinery › Milling Machines v
Face Mill

Thread Modes
Face Mill
Thumb Offline
Sophmore
***
Posts: 63
Threads: 10
Joined: Jun 2015
Location: Medford, Or
#9
07-11-2015, 11:45 PM (This post was last modified: 07-12-2015, 12:07 AM by Thumb.)
Found out how to remove and install the collet but looks like I'll need to buy some more collets. Any suggestions on where to get some at a good price?

Another question and probably not the last, I got the collet on but how does the chuck or any other kind of tool fasten onto the collet? The chuck I see slips onto the collet but what keeps it from falling off or turning?
Reply
Thanks given by:


Messages In This Thread
Face Mill - by Thumb - 07-11-2015, 07:11 PM
RE: Face Mill - by DaveH - 07-11-2015, 07:42 PM
RE: Face Mill - by EdK - 07-11-2015, 08:22 PM
RE: Face Mill - by Thumb - 07-11-2015, 08:49 PM
RE: Face Mill - by DaveH - 07-11-2015, 09:12 PM
RE: Face Mill - by Thumb - 07-11-2015, 11:24 PM
RE: Face Mill - by DaveH - 07-11-2015, 09:08 PM
RE: Face Mill - by EdK - 07-11-2015, 10:04 PM
RE: Face Mill - by Thumb - 07-11-2015, 11:45 PM
RE: Face Mill - by arvidj - 07-12-2015, 08:18 AM
RE: Face Mill - by Mayhem - 07-12-2015, 01:24 AM
RE: Face Mill - by Thumb - 07-12-2015, 01:48 AM
RE: Face Mill - by schor - 07-12-2015, 02:45 AM
RE: Face Mill - by Mayhem - 07-12-2015, 05:27 AM
RE: Face Mill - by Thumb - 07-12-2015, 01:13 PM
RE: Face Mill - by PixMan - 07-12-2015, 03:18 PM
RE: Face Mill - by Charles Spencer - 07-13-2015, 07:16 AM



Users browsing this thread: 3 Guest(s)