07-11-2015, 07:42 PM
Looks like a RF 25/30 mill.
Almost a certainty held in place with a draw bar. You will need to check the top of the spindle.
Undo the draw bar just one turn (from tight) and give the top of the draw bar a sharp tap preferably with a copper or brass headed mallet/hammer.
DaveH
Almost a certainty held in place with a draw bar. You will need to check the top of the spindle.
Undo the draw bar just one turn (from tight) and give the top of the draw bar a sharp tap preferably with a copper or brass headed mallet/hammer.
DaveH