MetalworkingFun Forum › Machining › General Metalworking Discussion v
[IDEA] Tool post grinder idea , belt sander upgrade.

Thread Modes
Idea Tool post grinder idea , belt sander upgrade.
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
EdK (06-17-2015)
#3
06-17-2015, 11:13 AM
You may be able to strip down the router to just a motor to make it smaller, but 1 1/2HP is a lot for a tool post grinder. You would have to watch the rpm's as well, so as to not over speed the wheel.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
RE: Tool post grinder idea , belt sander upgrade. - by TomG - 06-17-2015, 11:13 AM



Users browsing this thread: 1 Guest(s)