MetalworkingFun Forum › Machining › Projects v
Toolpost DTI holder

Thread Modes
Toolpost DTI holder
Micktoon Offline
Junior
****
Posts: 638
Threads: 43
Joined: Sep 2012
Location: England
#6
05-17-2015, 05:40 PM
Hi aRM , you have done cracking job and made the design better again, I had seen similar thing and tried to improve a touch so if it keeps going god knows what it might end up like lol. I think Bob KRV3000 is the refurb expert mind Worthy .
  I am sure you will be glad youmade it and wonder what you did before you had it.
  Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
Toolpost DTI holder - by aRM - 05-10-2015, 01:49 PM
RE: Toolpost DTI holder - by DaveH - 05-15-2015, 12:09 PM
RE: Toolpost DTI holder - by aRM - 05-15-2015, 01:14 PM
RE: Toolpost DTI holder - by Roadracer_Al - 05-16-2015, 01:34 PM
RE: Toolpost DTI holder - by krv3000 - 05-16-2015, 05:45 PM
RE: Toolpost DTI holder - by Micktoon - 05-17-2015, 05:40 PM
RE: Toolpost DTI holder - by aRM - 05-18-2015, 01:41 PM



Users browsing this thread: 1 Guest(s)