05-12-2015, 09:32 PM
Single acting with spring return as you made. Plan on tying into the down feed, which should only have about 300 psi, regulated pressure to give the down force on the bar that Oregon recommends.
Made the cylinder today from a piece of 3/4 stainless pipe I had. Was rather unique working with a known alloy, 304 , was stumped on the nipple I used. Bored it to get it round then reamed and honed it. Made a brass pistol with 2 o rings for seals, should have square quad rings but these were in stock.
Made the cylinder today from a piece of 3/4 stainless pipe I had. Was rather unique working with a known alloy, 304 , was stumped on the nipple I used. Bored it to get it round then reamed and honed it. Made a brass pistol with 2 o rings for seals, should have square quad rings but these were in stock.
Free advice is worth exactly what you payed for it.
Greg
Greg