05-01-2015, 07:01 PM
(05-01-2015, 07:38 AM)Highpower Wrote:(04-30-2015, 06:18 AM)stevec Wrote: So basically, the saw is driven by ahydraulic motorWisconsin engine with some increase of RPMs via jack shafts & pulley & belts.
Steve
(04-30-2015, 07:51 PM)stevec Wrote: " no hydraulics" ? I give up!
Steve
Steve, I think the saw chain is being powered directly from the Wisconsin engine, via belts with an electric clutch in between. Everything else runs off of the hydraulics. If not, I give up too.....
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.