MetalworkingFun Forum › Machining › General Metalworking Discussion v
Grafting feedscrew (Q from a new guy)

Thread Modes
Grafting feedscrew (Q from a new guy)
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#31
04-28-2015, 10:55 PM (This post was last modified: 04-28-2015, 10:56 PM by Dr Stan.)
(04-28-2015, 05:58 PM)DaveH Wrote: This will get me into a lot of trouble. Smile
Your lathe was designed by engineers made by machinists. Cool
Smiley-eatdrink004
DaveH

Yep, just when you think it's all blown over the anvil will drop.  Ouch
Reply
Thanks given by:


Messages In This Thread
Grafting feedscrew (Q from a new guy) - by Pete O - 04-24-2015, 07:10 AM
RE: Grafting feedscrew (Q from a new guy) - by Dr Stan - 04-28-2015, 10:55 PM



Users browsing this thread: 2 Guest(s)