How to square up an angle plate
#21
My shaper won't stop until the saddle runs off the end of the leadscrew. It needs me. Smile

The angle plate. If there's room, how about using a lathe to flycut it square? Bolt it down in place of the toolpost and rig up a cutter for the 4-jaw.
Here's one for the horizontal mills. Smiley-eatdrink004
Reply
Thanks given by:
#22
Oh, that I could have the room for such things as a horizontal machining center. I would rule the world!
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)