04-27-2015, 03:08 AM
A shrink fit with a tapered pin seems to be the way to go then.
In heating the female part to achieve this, how concerned should I be about the gear teeth? Am I likely to end up with annealed teeth, or is quenching with a wet rag as suggested by f350ca enough to harden them again?
I have some loctite 640 retaining compound, will have a look at their website and see if this is suitable.
In heating the female part to achieve this, how concerned should I be about the gear teeth? Am I likely to end up with annealed teeth, or is quenching with a wet rag as suggested by f350ca enough to harden them again?
I have some loctite 640 retaining compound, will have a look at their website and see if this is suitable.
Lathe (n); a machine tool used in the production of milling machine components.
Milling Machine (n); a machine tool used in the production of lathe components.
Milling Machine (n); a machine tool used in the production of lathe components.