03-26-2015, 09:15 PM
Thanks Willie, actually like my sleep, everyone around here knows not to even think about showing up before 10 or 11, I don't do mornings.
Problem of the day. Picked up two slow speed hydraulic motors on clearance, regular $260 for yes $65. Had a gear reducer off a small conveyor, it originally had a hydraulic motor coupled to it, but I stole it years ago for a power feed on a wood chipper. Had planned to mount one of the motors on the gear box, BUT the old motor must have been 5/8 shaft the new one is 1 inch. The input to the box is a keyed female hole with a flange mount for the motor. I can make an adaptor, 5/8 male with a keyway to 1 inch bore to fit the motor but how would I best cut a keyway in the blind hole?
Problem of the day. Picked up two slow speed hydraulic motors on clearance, regular $260 for yes $65. Had a gear reducer off a small conveyor, it originally had a hydraulic motor coupled to it, but I stole it years ago for a power feed on a wood chipper. Had planned to mount one of the motors on the gear box, BUT the old motor must have been 5/8 shaft the new one is 1 inch. The input to the box is a keyed female hole with a flange mount for the motor. I can make an adaptor, 5/8 male with a keyway to 1 inch bore to fit the motor but how would I best cut a keyway in the blind hole?
Free advice is worth exactly what you payed for it.
Greg
Greg