Billy G's Die Filer

[EdK]

(03-10-2015, 01:45 PM)DaveH Wrote: I'm still figuring how it all goes together.

I assume the Trunnion Rails go on the outside of the Side Plate(s).

On the drawing for the Side Plate (sheet 3) the vertical distance between the two 0.257" dia holes is 1.281-0.937 = 0.344"
On the drawing for the Left and Right Trunnion Rails (sheet 13) the vertical distance between the two 0.25" tapped holes is 1.312-0.9218 = 0.3902"
I was assuming the .257" dia holes were clearance holes for the .25" screw to hold the trunnion to the side plate.
Because the holes don't align up correctly may be I am assuming wrongly.
 
DaveH

Good stuff Dave.

Thanks for looking at this.

Ed