MetalworkingFun Forum › Machining › General Metalworking Discussion v
I found Pixman a new boring bar

Thread Modes
I found Pixman a new boring bar
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
The following 1 user Likes Mayhem's post:
EdK (12-23-2014)
#4
12-22-2014, 11:24 PM
(12-22-2014, 08:04 PM)dallen Wrote: I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.

DA

I don't think so Dave.  That bar looks solid enough to withstand use on your 7x12 Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
I found Pixman a new boring bar - by dallen - 12-22-2014, 05:02 PM
RE: I found Pixman a new boring bar - by PixMan - 12-22-2014, 07:25 PM
RE: I found Pixman a new boring bar - by dallen - 12-22-2014, 08:04 PM
RE: I found Pixman a new boring bar - by Mayhem - 12-22-2014, 11:24 PM
RE: I found Pixman a new boring bar - by Dr Stan - 12-28-2014, 11:26 PM



Users browsing this thread: 1 Guest(s)