+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: I found Pixman a new boring bar (/thread-2418.html)
I found Pixman a new boring bar - dallen - 12-22-2014
here is a photo of a boring bar that I said the next time I was in the store I would see about taking a photo of it. I had mentioned that it was 4" in dia. I was wrong its 3 inches in diameter and roughly 4 feet long.
its carbide is what I was told and from the scared up sticker on it the max load is 7000 N at 75 degrees C
[attachment=9734]
RE: I found Pixman a new boring bar - PixMan - 12-22-2014
Now that's a MAN'S boring bar!
RE: I found Pixman a new boring bar - dallen - 12-22-2014
I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.
DA
RE: I found Pixman a new boring bar - Mayhem - 12-22-2014
(12-22-2014, 08:04 PM)dallen Wrote: I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.
DA
I don't think so Dave. That bar looks solid enough to withstand use on your 7x12
RE: I found Pixman a new boring bar - Dr Stan - 12-28-2014
(12-22-2014, 11:24 PM)Mayhem Wrote:(12-22-2014, 08:04 PM)dallen Wrote: I was going to pick it up for use on my 7X12 but figured that I'd probably just break it.
DA
I don't think so Dave. That bar looks solid enough to withstand use on your 7x12
I think he meant that he'd break the 7X12