05-11-2012, 01:31 PM
(This post was last modified: 05-11-2012, 01:37 PM by henryarnold.)
In this post and the next one, I'll reinstall various plugs, seals and vents. I'm now on the home stretch.
Reinstall the plastic plugs that cover the Intermediate bearing shafts. You may recall we removed these by drilling a small hole and inserting a sheet metal screw to pull them out.
I used some white grease to make them slide in easier. I had to work the o-ring to get it to slide into the bore.
Installing the plugs.
I plugged the screw holes with paint-able caulk.
I next installed the motor seal with the tool I made.
Carefully tap it in place while keeping level.
Motor seal installation complete.
Reinstall the plastic plugs that cover the Intermediate bearing shafts. You may recall we removed these by drilling a small hole and inserting a sheet metal screw to pull them out.
I used some white grease to make them slide in easier. I had to work the o-ring to get it to slide into the bore.
Installing the plugs.
I plugged the screw holes with paint-able caulk.
I next installed the motor seal with the tool I made.
Carefully tap it in place while keeping level.
Motor seal installation complete.
henryarnold, proud to be a member of MetalworkingFun Forum since Apr 2012.