10-20-2014, 10:16 PM
Interesting project! I've seen similar ideas using needle nose pliers drilled & tapped in different sizes along the jaws, to use for holding and shortening small screws on a grinder.
I just stuffed a wad of cleaning patches in the bottom of my kinetic puller to cushion the bullet nose when they come loose, rather than smacking into the base of the puller tube. I helps to lighten up on the swing though when they get close to coming out of the case neck.
I wonder if you made one of the other style pullers with something like aluminum plate if they would grip better? Maybe drill a bit undersize and then ream them to final size?
I just stuffed a wad of cleaning patches in the bottom of my kinetic puller to cushion the bullet nose when they come loose, rather than smacking into the base of the puller tube. I helps to lighten up on the swing though when they get close to coming out of the case neck.
I wonder if you made one of the other style pullers with something like aluminum plate if they would grip better? Maybe drill a bit undersize and then ream them to final size?
Willie