MetalworkingFun Forum › Machining › General Metalworking Discussion v
And he should no better lol

Thread Modes
And he should no better lol
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#15
10-16-2014, 07:39 AM
(10-16-2014, 12:28 AM)TomG Wrote: ...or he could have conventional milled from the center of the part. That would have tightened the part on the threads.

Tom

I'm not sure I get this part...
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
And he should no better lol - by RobWilson - 10-13-2014, 10:13 AM
RE: And he should no better lol - by EdK - 10-13-2014, 10:37 AM
RE: And he should no better lol - by DaveH - 10-13-2014, 12:04 PM
RE: And he should no better lol - by TomG - 10-13-2014, 12:13 PM
RE: And he should no better lol - by Highpower - 10-13-2014, 12:31 PM
RE: And he should no better lol - by Dr Stan - 10-13-2014, 06:51 PM
RE: And he should no better lol - by Mayhem - 10-14-2014, 05:43 AM
RE: And he should no better lol - by Highpower - 10-14-2014, 11:11 AM
RE: And he should no better lol - by Highpower - 10-15-2014, 01:29 PM
RE: And he should no better lol - by Dr Stan - 10-15-2014, 10:30 PM
RE: And he should no better lol - by Highpower - 10-15-2014, 11:51 PM
RE: And he should no better lol - by TomG - 10-16-2014, 12:28 AM
RE: And he should no better lol - by Highpower - 10-16-2014, 09:58 AM
RE: And he should no better lol - by Mayhem - 10-16-2014, 07:39 AM
RE: And he should no better lol - by TomG - 10-16-2014, 08:37 AM



Users browsing this thread: 5 Guest(s)