MetalworkingFun Forum › Machining › General Metalworking Discussion v
Open end wrench as a caliper.

Thread Modes
Open end wrench as a caliper.
ETC57 Offline
Junior
****
Posts: 576
Threads: 18
Joined: Feb 2012
Location: Washington State USA
#9
05-07-2012, 08:53 AM
Hay Mike,

Your not alone, it never a cured to me ether, 17428Slaphead

the few the proud the unaware! RotflRotfl



Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Open end wrench as a caliper. - by aametalmaster - 05-06-2012, 05:13 PM
RE: Open end wrench as a caliper. - by EdK - 05-06-2012, 05:28 PM
RE: Open end wrench as a caliper. - by DaveH - 05-06-2012, 05:39 PM
RE: Open end wrench as a caliper. - by stevec - 05-06-2012, 06:45 PM
RE: Open end wrench as a caliper. - by mikecwik - 05-06-2012, 09:20 PM
RE: Open end wrench as a caliper. - by EdK - 05-07-2012, 06:15 AM
RE: Open end wrench as a caliper. - by ETC57 - 05-07-2012, 08:53 AM



Users browsing this thread: 1 Guest(s)