MetalworkingFun Forum › Machining › General Metalworking Discussion v
Open end wrench as a caliper.

Thread Modes
Open end wrench as a caliper.
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#8
05-07-2012, 06:15 AM
(05-06-2012, 09:20 PM)mikecwik Wrote: i guess i should be embarrassed to say that im the guy that didnt consider that but ironically i was born with out the key enzyme that processes shame.

Good one Mike!

Ed
Reply
Thanks given by:


Messages In This Thread
Open end wrench as a caliper. - by aametalmaster - 05-06-2012, 05:13 PM
RE: Open end wrench as a caliper. - by EdK - 05-06-2012, 05:28 PM
RE: Open end wrench as a caliper. - by DaveH - 05-06-2012, 05:39 PM
RE: Open end wrench as a caliper. - by stevec - 05-06-2012, 06:45 PM
RE: Open end wrench as a caliper. - by mikecwik - 05-06-2012, 09:20 PM
RE: Open end wrench as a caliper. - by EdK - 05-07-2012, 06:15 AM
RE: Open end wrench as a caliper. - by ETC57 - 05-07-2012, 08:53 AM



Users browsing this thread: 1 Guest(s)