|
Tool and Cutter Grinder
|
08-10-2014, 06:12 PM
I should have said "Making an air bearing well is pretty much beyond the reach of the home machine shop". Two thousandths clearance is going to allow the spindle to move around a lot more than I'd like to see for sharpening end mills. I suppose if one was willing to invest the time, the spindle could be lapped for a closer fit.
Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 12:04 AM
RE: Tool and Cutter Grinder - by stevec - 02-26-2014, 07:00 AM
RE: Tool and Cutter Grinder - by Hawkeye - 02-26-2014, 09:55 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 01:18 PM
RE: Tool and Cutter Grinder - by stevec - 02-27-2014, 07:15 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 12:01 AM
RE: Tool and Cutter Grinder - by Old Iron - 03-09-2014, 03:33 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-09-2014, 10:05 PM
RE: Tool and Cutter Grinder - by stevec - 03-10-2014, 06:13 AM
RE: Tool and Cutter Grinder - by Dr Stan - 08-10-2014, 11:31 AM
RE: Tool and Cutter Grinder - by Hawkeye - 03-10-2014, 08:33 PM
RE: Tool and Cutter Grinder - by RobWilson - 08-10-2014, 01:32 PM
RE: Tool and Cutter Grinder - by TomG - 08-10-2014, 06:12 PM
RE: Tool and Cutter Grinder - by stevec - 08-10-2014, 06:34 PM
RE: Tool and Cutter Grinder - by ieezitin - 08-11-2014, 04:23 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 06:30 PM
RE: Tool and Cutter Grinder - by TomG - 08-11-2014, 06:53 PM
RE: Tool and Cutter Grinder - by DaveH - 08-11-2014, 07:02 PM
|
